Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Ficha De Dados

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

This function sets the throttle cut position for 

auto rotation. The throttle servo operating speed 

can be adjusted. (Speed)

●Servo speed

 Use the Condition select menu of the Model

menu to assign the hold condition switch.

 Selection example: SG

 Move the cursor to the hold position item

and touch the RTN button to switch to the

data input mode.

 Adjust the rate by scrolling the touch sensor.
 Initial value: 17%
 Adjustment range: 0%~50%

*Hold position sets the throttle cut position. Adjust it so that 

the carburetor is completely closed.

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

 Move the cursor to the servo speed item and

touch the RTN button to switch to the data

input mode.

 Adjust the rate by scrolling the touch sensor.
 Initial value: 0
 Adjustment range: 0~27 (maximum delay)

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to return to the cursor

mode.

● Select [THR HOLD] at the Model menu

and access the setup screen shown

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

●Hold position setting

●Hold position
●Current position

When actually starting the engine and flying, 

always set the idle up condition switch to OFF 

and start the engine at idle.