Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Ficha De Dados

Initially, the T14SG assigns the first model to 

model-01 in the transmitter. To add new models 

or to select a model already programmed, use the 

Model Select function of the Linkage Menu. 

This is convenient when selecting a model 

after entering the model's names in advance. The 

T14SG is capable of storing up to 30 models in the 

transmitter's internal memory.  Additional models 

can also be stored in an optional SD card.

The currently selected model is displayed in 

the middle of the screen. Before flying and before 

changing any settings, always confirm the model 

name. 

When a new model is added, the Model Type select 

screen and system mode setup screen automatically 

appear. Change, or check that they match the swash 

type and receiver type of the model used.

When a new model is added, you will need to re-

link the receiver.

If a different model type is already selected, 

select helicopter with the Model Type function of 

the Linkage Menu, and then select the swash type 

matched to the helicopter.

*The Model Type function automatically selects the 

appropriate output channels, control functions, and mixing 

functions for the chosen model type. Six swash types are 

This section outlines examples of use of the helicopter functions of the T14SG. Adjust the actual values, 

etc. to match the fuselage used.

available for helicopters.

*For a description of the swash type selection, refer to the 

MODEL TYPE function.

The transmitter offers up to five flight conditions 

per model. 

The Condition Select function automatically 

allocates five conditions for helicopters.

 (Initial setting)
 ● NORMAL
 ● IDLE UP1 (SW-E)
 ● IDLE UP2 (SW-E)
 ● IDLE UP3 (SW-F)
 ●HOLD (Hold switch is not assigned initially)

*For a description of the condition deletion, refer to the 

Condition Select function.

The NORMAL condition is always on, and 

remains on until other conditions are activated by 

switches.

The priority is throttle hold/idle up 3/idle up 

2/idle up 1/normal. Throttle hold has the highest 

priority.

The Condition Delay can be programmed for 

each channel and condition. The Condition Delay 

is used to change the servo throw smoothly when 

switching conditions.
(General flight condition setting example)

● Normal: (Use initial setting conditions/operate

when switch OFF)

Use from engine starting to hovering.

● Idle up 1: (Operate at SW-E center)

Use in stall turn, loop, and other maneuvers.

● Idle up 2: (Operate at SW-E forward side)

Use in rolls.

● Throttle hold: (Operate at SW-G forward side)

Use in auto rotation.