Vocopro Car Amplifier HV-1200 Manual Do Utilizador

Getting Connected cont.

Connecting Power

What you will need:

• Surge Protector (recommended) or power outlet

• Included power cable

To connect Power to the HV-1200

1. Connect one end of the power cable to the rear 

panel of the HV-1200.

2. Connect the other end of the power cable to the 

power outlet or surge protector.

Connecting Speakers

The Speaker Terminals are located on the rear panel.  Be sure to connect the left channel (L), right channel (R), “+” 

(red) and “--” (black) properly.  

• Before connecting the speakers, make sure that the HV-1200 is 

disconnected from the power source.

• Do not let the bare speaker wires touch each other or another metal part 

of this unit.  This could damage the HV-1200 and/or the speakers.

Preparing the Speaker Cable

You can either use an exposed speaker wire or Banana Plug speaker cable.

Using Exposed Speaker Wire

1. Remove approximately 3/8” (10mm) of insulation.

2. Twist the exposed wires together to prevent short circuits.

3. Loosen the knob on the speaker terminal.

4. Insert the bare wire.

5. Tighten the knob until the wire is secure.

Using Banana Plugs

1. Plug the Banana Connector into the jack, 

ensuring that the red and black connections 

are aligned.

������

������

��������

�

�

�����������

��������������������

�������������������

�������

���������

������������

���������������������

����������

������������������

�������������
�������������

�������������

�

�

�

����������������

����

�

�