Vocopro Car Stereo System CD-6000RV Manual Do Utilizador

Connecting Speakers

The Speaker Terminals are located on the rear panel.

There are two SPEAKER terminals. Be sure to connect the

left channel (L), right channel (R), “+” (red) and “--” (black)

properly.

��

• Before connecting the speakers, make sure that the CDG-

6000RV is disconnected from the power source.

• Do not let the bare speaker wires touch each other or

another metal part of this unit. This could damage the

CDG-6000RV and/or the speakers.

Determining the proper way to connect the speaker

cables:

The speaker cable is a pair of insulated cables running side

by side. One cable is colored or shaped differently , perhaps

with a stripe, groove or ridges.

1. Connect one end of the striped (grooved, ridged, etc.)

cable to the “+” (red) terminal on the rear panel of the

CDG-6000RV.

2. Connect the other end of the striped (grooved, ridged,

etc.) cable to the “+” (red) terminal on the speaker.

3. Connect one end of the “plain” (NO stripes, grooves,

ridges, etc.) cable to the “--” (black) terminal on the rear

panel of the CDG-6000RV.

4. Connect the other end of the “plain” (NO stripes, grooves,

ridges, etc.) cable to the “--” (black) terminal on the

speaker

��

Preparing the Speaker Cable

You can either use an exposed speaker wire or Banana Plug

speaker cable.

Exposed Speaker Wire

1. Remove approximately 3/8” (10mm) of insulation

��

2. Twist the exposed wires together to prevent short circuits

4. Insert the bare wire
5. Tighten the knob until the wire is secure

�

��

Getting Connected cont.