Viper 5706V Manual Do Proprietário
42
© 2013 Directed. All rights reserved.
42
Out of Range
Each time a command is performed the remote will expect a com-
mand confirmation from the system. If a command confirmation is not
received the out-of-range icon (
mand confirmation from the system. If a command confirmation is not
received the out-of-range icon (
)
and a fault tone will play as an
alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.
Feature not Available
The
NOT AVAILABLE
message is a generic one which varies in cause
and solution depending upon the command used:
Command
Cause
Reason/Solution
Runtime Reset
Remote Start is Off
Only available when Remote Start is On
Sensor Bypass
System is not armed
Only available when system is armed
Defroster
Remote Start is Off.
Not configured for
this.
Not configured for
this.
Only available when Remote Start is On.
Only available when configured for
Defroster control.
Only available when configured for
Defroster control.