StorageTek Host Software Component 6 Manual Do Utilizador

1st ed., 6/30/04 - 312579601

An HSC operator command, SRVlev, sets a different service level. Refer to information 
presented on the Display command in Chapter 2, ‘‘Commands, Control Statements, and 
Utilities’’ in the HSC Operator’s Guide for information on how to display the current HSC 
service level. 

If the HSC and the library are new to your data center, you may want to install the HSC 
software and start the subsystem at the base service level before your library hardware is 
physically installed. Starting the HSC at the base service level allows you to perform 
many of the preliminary tasks involved in configuring your library and performing 
preliminary tests on basic operation. 

Normally the HSC subsystem is initialized to the full service level when started. The HSC 
can be started at the base service level only by specifying the BASE parameter in the 
startup SLKJCL file. Then, the Service Level (SRVlev) command can be used to bring the 
HSC to full service level whenever you are ready. 

Refer to “Initializing the HSC to the Base Service Level” on page 129 for information 
about setting the service level at HSC initialization.