SMC Networks TIGERSWITCH 10/100 Manual Do Utilizador
SNMP C
OMMANDS
3-59
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server enable traps command,
no notifications controlled by this command are sent. In order
to configure this device to send SNMP notifications, you must
enter at least one snmp-server enable traps command. If you
enter the command with no keywords, both authentication and
link-up-down notifications are enabled. If you enter the
command with a keyword, only the notification type related to
that keyword is enabled.
no notifications controlled by this command are sent. In order
to configure this device to send SNMP notifications, you must
enter at least one snmp-server enable traps command. If you
enter the command with no keywords, both authentication and
link-up-down notifications are enabled. If you enter the
command with a keyword, only the notification type related to
that keyword is enabled.
The snmp-server enable traps command is used in
conjunction with the snmp-server host command. Use the
snmp-server host command to specify which host or hosts
receive SNMP notifications. In order to send notifications, you
must configure at least one snmp-server host command.
conjunction with the snmp-server host command. Use the
snmp-server host command to specify which host or hosts
receive SNMP notifications. In order to send notifications, you
must configure at least one snmp-server host command.
Example
Related Commands
show snmp
Use this command to check the status of SNMP
communications.
communications.
Default Setting
None
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Console(config)#