Simplicity SA200 Manual Do Utilizador
7
The Simplicity sewing machine has many conversion options for a multitude of sewing
applications.
applications.
SIMPLICITY SEWING MACHINE SET-UP
The power cord and foot control are one unit.
Insert the three-prong plug into the machine [Fig. 1].
Insert the power supply plug into a wall outlet. Turn the
power switch to “on” [Fig.1].
Raise the left retractable thread spool pin for most sewing
[Fig. 2]. Raise both the left and right retractable thread
spool pins for twin needle or dual thread sewing.
Insert the three-prong plug into the machine [Fig. 1].
Insert the power supply plug into a wall outlet. Turn the
power switch to “on” [Fig.1].
Raise the left retractable thread spool pin for most sewing
[Fig. 2]. Raise both the left and right retractable thread
spool pins for twin needle or dual thread sewing.
Your Simplicity sewing machine comes with both snap-
on and screw-on presser feet. They're easy to change
and each foot helps make a specific sewing task easier.
Removing and Attaching Snap-on Presser Feet
1. Turn the handwheel toward you [Fig. 3] to bring the
on and screw-on presser feet. They're easy to change
and each foot helps make a specific sewing task easier.
Removing and Attaching Snap-on Presser Feet
1. Turn the handwheel toward you [Fig. 3] to bring the
needle to its highest position.
2. Raise the presser foot lever [Fig. 4].
3. Release the foot by pushing the presser foot release
3. Release the foot by pushing the presser foot release
lever located behind the presser foot holder [Fig. 5].
4. Place the desired foot on the needle plate, aligning
the metal bar on the presser foot with the groove of
the presser foot holder [Fig. 6].
the presser foot holder [Fig. 6].
5. Lower the presser foot lever to snap the foot in place.
Removing and Attaching Screw-on Presser Feet
1. Loosen the thumb screw located on the left side of the
Removing and Attaching Screw-on Presser Feet
1. Loosen the thumb screw located on the left side of the
presser foot on the presser foot bar [Fig. 7]. You may
need to use the screwdriver. It is not necessary to
remove the screw all the way.
need to use the screwdriver. It is not necessary to
remove the screw all the way.
3. Remove the presser foot holder and foot [Fig. 8].
4. Attach the desired screw-on presser foot onto the
4. Attach the desired screw-on presser foot onto the
presser bar.
5. Tighten the thumb screw with the screwdriver to hold
the presser foot securely in place [Fig. 9].
Note: After attaching a presser foot, select the desired
stitch and turn the hand-wheel toward you several times to
make sure the needle clears the opening in the foot. Some
presser feet require a straight or narrow width stitch only.
stitch and turn the hand-wheel toward you several times to
make sure the needle clears the opening in the foot. Some
presser feet require a straight or narrow width stitch only.
Insert the guide, from right to left, through the small
hole near the back of the presser foot holder [Fig. 10].
hole near the back of the presser foot holder [Fig. 10].
PREPARATION FOR SEWING
CHANGING PRESSER FEET
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 2
on/off
Fig. 9
Fig. 10
Fig. 8
ATTACHING SEAM GUIDE