ResMed ELITE S8 Manual Do Utilizador
10
3
Remove the Data Card by gripping the end of the Data Card and pulling it out.
4
Store the Data Card in its protective folder when not in use.
5
Return the card in its protective folder to your clinician using a postal envelope.
Using the Data Card to Update Settings
If your clinician has provided a Data Card with new device settings:
1
With the device in standby (Ramp) mode, insert the Data Card into the Data Card
slot. Updating will start automatically.
The “Card Inserted Please Wait” message is displayed on the LCD while
updating is in progress. Updating takes approximately five seconds.
The “Settings Success Remove Card” message is displayed on the LCD if the
settings were updated successfully.
slot. Updating will start automatically.
The “Card Inserted Please Wait” message is displayed on the LCD while
updating is in progress. Updating takes approximately five seconds.
The “Settings Success Remove Card” message is displayed on the LCD if the
settings were updated successfully.
Note: This message only appears once. If you re-insert the Data Card after you
have updated your settings, this message is not displayed.
have updated your settings, this message is not displayed.
2
Remove the Data Card from the S8 Series II.
3
Store the Data Card in its protective folder when not in use.
!
WARNING
If your clinician has told you to use this Data Card to update the settings on your
device and the “Settings Success” message does not appear, contact your
clinician immediately.
device and the “Settings Success” message does not appear, contact your
clinician immediately.
Cleaning and Maintenance
!
WARNING
Beware of electric shock. Do not immerse the device or power cord in water.
Always unplug the device before cleaning and make sure it is dry before
reconnecting.
Always unplug the device before cleaning and make sure it is dry before
reconnecting.
!
CAUTION
•
Do not hang the air tubing in direct sunlight as it may harden over time
and eventually crack.
and eventually crack.
• Do not use bleach, chlorine, alcohol, or aromatic-based solutions,
moisturizing or antibacterial soaps or scented oils to clean the air tubing or
the device. These solutions may cause hardening and reduce the life of the
product.
the device. These solutions may cause hardening and reduce the life of the
product.
Daily
Disconnect the air tubing and hang it in a clean, dry place until next use.
Weekly
1
Remove the air tubing and wash it in warm water using mild detergent
.