Pertech A470 Manual Do Utilizador

A470 Users Guide

Pertech® 2006

12

The A470 produces a printout listing the current configuration settings. A sample printout is 

included below. Receipt and Receipt/Journal printers will print a Self Test / Configuration Report if 

the Paper Advance Button on the top cover is pressed and held while the printer power is turned 

ON.

Validation printers will perform a Self Test / Configuration Report if a form is detected  

 

when the power is turned on. 

Two reports are available:

Self Test / Configuration Report : Includes read and write tests of internal RAM; and a printed 

report listing the serial number, firmware, font, serial parameters,  hardware settings, memory 

information, tallies, and the printer compatibility mode.

Extended Self Test: Checks printhead pin firing, vertical line adjustment, fonts, 

validation clamp,  pitches and character sets.

If you want to run the Extended Self Test , continue to hold the Paper Feed Button  

 

while the printer prints the Configuration Report. After the Configuration Report is done    

printing the printer will begin printing the Extended Self Test. The Extended Self Test  

 

performs a printhead pin firing test, character drop test, checks the vertical line adjust 

 

ments, fonts, validation clamp,  pitches and character sets.

PERTECH RESOURCES INC. 47XX
REVISION X.XX MK XXXX

INT9A   FONT  

7K  RAM  BUFFER

USA  CHARACTER  SET 
8  BIT  -  SERIAL  INTERFACE 
DATA RATE  ( BAUD )  =  9600 
RTS  BUSY  POLARITY   = -12V  (MARK)
AUTO  LF  WITH  CR  =  OFF
CHARACTERS  /  LINE  =  40 
JOURNAL  LPI = 6  /  VALIDATE  LPI = 6
DEFAULT  CLAMP  =  CLOSED
RIGHT  MARGIN  CLOCKS  =  207
DIP  SWITCH  “A”  SETTING  =  OOCOCCOO
DIP  SWITCH  “B”  SETTING  =  OCOOOOOO

1    2    3    4    5    6    7    8    9 

1. If necessary turn the printer off.

2. Press and hold the Paper Feed Button and 

then press the Power Button to the ON position. 

Release the Paper Feed Button when the printer 

begins printing.