Olitec RW400G Manual Do Utilizador

 

After connecting the RW400G Router into your network, you should configure it. This 
chapter describes how to configure the basic functions of your RW400G Wireless Router. 
These procedures only take you a few minutes. You can access the Internet via the 
router immediately after successfully configured. 

The default IP address of the RW400G Wireless Router is 192.168.1.1, and the default 
Subnet Mask is 255.255.255.0. These values can be seen from the LAN. They can be 
changed as you desire, as an example we use the default values for description in this 
guide. 

Connect the local PCs to the LAN ports on the router. There are then two means to 
configure the IP address for your PCs. 

¾

 

Configure the IP address manually 
1)  Set up the TCP/IP Protocol for your PC(s). If you need instructions as to how to 

 

2)  Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is 

from 2 to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1 
(The router's default IP address) 

¾

 

Obtain an IP address automatically 
1)  Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on 

your PC(s). If you need instructions as to how to do this, please refer to 

 

2)  Power off the router and PC(s). Then turn on the router, and restart the PC(s). 

The built-in DHCP server will assign IP addresses for the PC(s). 

Now, you can run the Ping command in the command prompt to verify the network 
connection between your PC(s) and the router. The following example is in Windows 
2000 OS. 

Open a command prompt, and type ping 192.168.1.1, then press Enter. 

 

 

 

 

        Figure 4-1: Successful result of Ping command 

 - 

6 -