McCulloch MCS2001 Manual Do Utilizador

NOTE: Locate small bag of hardware containing two Allen
hex screws, two large flat washers, two small flat washers
and two split pins.
1.

Place one wheel on the axle followed by a large flat
washer. Secure by inserting a split pin through the
hole in the end of the axle, bend the ends over using
pliers. See Figure 3-1A.

2.

Press wheel cover on wheel.

3.

Position the axle assembly on the inside of the sup-
port tube as shown in Figure 3-1B, aligning the hole in
the axle with the hole in the support. Place a lock-
washer and small flat washer on the Allen hex screw
and guide them up through the hole in support tube
and into the hole in the axle. The flat washer should be
next to the axle.

4.

Assemble the other tube support to the other end of
the axle in the same manner.

5.

Attach the second wheel to the axle using the same
method as described in step 1.

1.

Remove feeder tube by loosening & spring loaded
knobs. Figure 3-2A.

2.

Lay motor assembly down on flat surface with plug
facing down.

3.

Place a 2x4 under bottom of motor to obtain correct
angle to attach wheel kit.

4.

Wheels should be toward floor (same as plug).

5.

Align top of support tubes (2 holes) with 2 holes in
motor housing. Using hardware (fiat washers of lock
washers, and 4 hex bolts attach support tubes to
motor housing & tighten.

6.

Stand unit of and reattach feeder. Tube by tightening 3
spring loaded knobs.

Use caution when tightening set screws to avoid contact
with sharp cutting blades.

15.

The operation of any tool can result in foreign
objects being thrown into your eyes, which can

result in severe eye damage. Before operating power
tool, always wear safety goggles or safety glasses with
side shields and a full face shield when needed. We rec-
ommend wide Vision Safety Mask for use over eye-
glasses or standard safety glasses with side shields.

1.

A 

NOTE is used to convey additional information, or

highlight a particular explanation, or to expand a
instruction.

2.

A 

WARNING identifies a procedure which, if not

undertaken or if improperly done, can result in a seri-
ous personal injury or damage to the unit and/or both.

3.

(

WARRANTY SYMBOL) serves notice that

unless instructions or procedures are followed,

any damage will void the warranty and repairs will be
at owner’s expense. Service other than user mainte-
nance should be performed by a McCulloch
Authorized Service Center. Damage or conditions
caused BY improper maintenance practices which
render this product inoperable will void the manufac-
turer’s warranty.

4.

FOR WARRANTY OR SERVICE contact the nearest
McCulloch Authorized Service Center.

1.

Never place hands into discharge chute as serious
injury will occur  (Figure 2-1).

2.

Use of these personal safety items is highly recom-
mended to reduce the risk of accidental injury (Figure
2-2).

6

7

Use of these personal safety items is
highly recommended to reduce the risk
of accidental injury.

Never place hands into discharge
chute as serious injury will occur.

Allen hex screw,
small flat washer
and lockwasher