Hitachi Chainsaw CS 33EB Manual Do Utilizador

Fill up with chain oil (13). Always use good quality 

chain oil. When the engine is running, the chain oil is 

automatically discharged.

  When pouring fuel (12) or chain oil (13) into the 

tank, place the unit with cap side up. (Fig. 8)

1.  Set ignition switch (14) to ON position. (Fig. 9)

14

Fig. 9

2.  Pull the choke lever (15) down to choked position 

(Fig. 10).  This will automatically lock the throttle in 

starting position. (Fig. 9)

15

Fig. 10

3.  Pull recoil starter briskly, taking care to keep the 

handle in your grasp and not allowing it to snap 

back. (Fig. 9)

4.  When you hear fi rst ignition, return the choke to 

run position. (Fig. 10)

5. Pull recoil starter briskly again in the 

aforementioned manner. (Fig. 11)

  After engine starts, make sure the chain brake is 

disengaged.

Fig. 11

  If engine does not start, repeat procedures from 

2 to 5.

6.  After starting engine, allow the engine about 2–3 

minutes to warm up before subjecting it to any 

load.

Chain brake (16), if so equipped, is designed to 

activate in an emergency such as kick-back action. 

Please check to verify that it works properly before 

use.

Application of brake is made by moving the front 

guard towards the bar. During the chain brake 

operation, even if the throttle lever is pulled, the 

engine speed does not increase and the chain does 

not turn. To release the brake, pull up the chain 

brake lever.

16

Fig. 12

1) Turn off  the engine.

2)  Holding the chain saw horizontally, release your 

hand from the front handle, hit the tip of the guide 

bar to a stump or a piece of wood, and confi rm 

brake operation. Operating level varies by bar 

size.

10

000Book_CS33EB_US.indb   10

000Book_CS33EB_US.indb   10

2009/09/04   10:24:49

2009/09/04   10:24:49