Bolens 416 Manual Do Serviço
14
SECTION 9: TROUBLE SHOOTING GUIDE
NOTE: For repairs beyond those listed above, contact a Bolens authorized service dealer.
Trouble
Possible Cause(s)
Corrective Actions
Engine fails to
start
start
1.
Blade control handle disengaged.
2.
Spark plug wire disconnected.
3.
Dirty aircleaner.
4.
Primer button not depressed.
5.
Throttle control lever (if so equipped) not in
correct starting position .
correct starting position .
6.
Fuel tank empty or stale fuel.
7.
Blocked fuel line
8.
Faulty spark plug.
9.
Engine flooded.
1.
Engage blade control handle.
2.
Connect wire to spark plug.
3.
Refer to the engine manual.
4.
Refer to the engine manual.
5.
Move throttle lever to FAST or START position.
6.
Fill tank with clean fresh gasoline.
7.
Clean fuel line.
8.
Clean, adjust gap or replace.
9.
Refer to the engine manual.
Engine runs
erratic
erratic
1.
Spark plug wire loose.
2.
Blocked fuel line, if equipped, or stale fuel.
3.
Vent in gas cap plugged.
4.
Water or dirt in fuel system.
5.
Dirty air cleaner.
6.
Carburetor out of adjustment.
1.
Connect and tighten spark plug wire.
2.
Clean fuel line; fill tank with clean, fresh gasoline.
3.
Clear vent or threads or replace.
4.
Drain fuel tank. Refill with fresh fuel.
5.
Refer to the engine manual.
6.
Refer to the engine manual.
Engine
overheats
overheats
1.
Engine oil level low.
2.
Dirty aircleaner.
3.
Air flow restricted.
4.
Carburetor not adjusted properly.
1.
Fill crankcase with proper oil.
2.
Refer to the engine manual.
3.
Stop engine and disconnect spark plug wire.
Remove blower housing and clean.
Remove blower housing and clean.
4.
Refer to the engine manual.
Occasionally
skips at high
speed
skips at high
speed
1.
Spark plug gap too close.
2.
Carburetor idle mixture adjustment
improperly set.
improperly set.
1.
Adjust gap to .030".
2.
Refer to the engine manual packed with your unit.
Idles poorly
1.
Spark plug fouled, faulty or gap too wide.
2.
Carburetor improperly adjusted.
3.
Dirty air cleaner.
1.
Reset gap to .030" or replace spark plug.
2.
Refer to the engine manual.
3.
Refer to the engine manual.
Excessive
vibration
vibration
1.
Cutting blade loose or unbalanced.
2.
Bent cutting blade.
1.
Tighten blade and adapter. Balance blade.
2.
See an authorized service dealer.
Mower will not
mulch grass
mulch grass
1.
Wet grass.
2.
Excessively high grass.
1.
Do not mow when grass is wet; wait until later to cut.
2.
Mow once at a high cutting height, then mow again
at desired height or make a narrower cutting swath
(1/2 width).
at desired height or make a narrower cutting swath
(1/2 width).
Uneven cut
1.
Wheels not positioned correctly.
2.
Dull blade.
1.
Place all four wheels in same height position.
2.
Sharpen or replace blade.