Weil-McLain PLUS LINE PLUS-E017-A/1206 Manual Do Utilizador

Part Number PLUS-E017-A/1206

19

   • Installation   • Start-Up   • Usage   • Maintenance   • Parts

Studies have indicated that dangerous bacteria, including legionella pneumophila, can form in the potable

water  distribution  system  if  certain  minimum  water  temperatures  are  not  maintained.  Contact  your  local

health department for more information.

Water  heater  thermostat  is  factory  set  to  its  lowest  tem-

perature. The arrowhead indicator

on the label is the

preferred starting point for setting temperature. This may

or may not be suitable for your needs.
Turn thermostat knob



to increase

water

temperature.
Turn thermostat knob



water temperature.
When decreasing temperature setting, the stored hot water

must be used before checking temperature at faucet.
Check water temperature at a hot water faucet immediately

after  first  heating  cycle.  Further  temperature  adjustment

may be necessary as water heating system is used. Recheck

water temperature at faucet after adjustment.
When adjusting thermostat, be sure boiler limit control is

set a minimum 20°F higher.

Water  heater  thermostat  is  factory  set  to  its  lowest  tem-

perature. The white factory setting mark on the label is the

preferred starting point for setting temperature. This may

or may not be suitable for your needs.
Turn thermostat knob



water

temperature.
Turn thermostat knob



water temperature.
When decreasing temperature setting, the stored hot water

must be used before checking temperature at faucet.
Check water temperature at a hot water faucet immediately

after  first  heating  cycle.  Further  temperature  adjustment

may be necessary as water heating system is used. Recheck

water temperature at faucet after adjustment.
When adjusting thermostat, be sure boiler limit control is

set a minimum 20°F higher.

At no time should boiler limit control be

set above 210°F. This can cause severe

personal    injury,  death  or  substantial

property damage if ignored.

At no time should boiler limit control be

set above 210°F. This can cause severe

personal  injury,  death  or  substantial

property damage if ignored.

A5