Sonic Alert DB100 Folheto

Página de 2
 
Setting the Audio Switch:
   
         Top - OFF 
                                                    Bottom - ON                              
 
Located on the DB100 Signaler (larger unit):
   
The speaker switch allows you to turn the Audio Alarm ON or 
OFF.  ON is down and OFF is up.        
 
   
Multi-Function Input Jack: 
Located on the right side of the DB Sensor, this input jack is 
for installations as shown below in diagram 2 & 3. 
                      
 
 
                       
DB100 INSTALLATION DIAGRAMS 
 
 
 
 
 
 
 
                                          
Battery free installation (diagram 3):  
Use wire provided, plug into jack outlet on side of 
Transmitter. Remove chime cover and connect the red 
and yellow wires to chime box terminal screws common 
and front. 
 
 
 
 
 
 
 
 
 
Troubleshooting & Help:  
 
If you’ve followed the directions and are still having problems 
please try the following suggestions: 
 
1) Check battery in the sensor. Must be a 12-volt alkaline type. 
 
2) Check dip switch settings. Both the sensor and the signaler 
must match as shown in figure 1.1 above. 
  
3) Check outlet for power. 
 
4) Move the Signaler to an outlet closer to the sensor unit. 
 
5) If using the Multi-Function input jack make sure that the wires 
are not touching each other. See diagram number 2 & 3 for 
proper installation. 
 
6) Check that sensor is not further than 50 feet from the receiver. 
 
7) Do not place sensor on steel doors or steel door frames. 
 
 
For Technical help call 1-248-577-5400 
M-F 8:00 a.m. – 5:00 p.m. Eastern Time 
Or e-mail us with your questions at sonic-info@sonicalert.com  
 
Warranty: 
 
Thank you for purchasing this high quality Sonic Alert product. We hope you 
will have many years of satisfied use. This Sonic Alert product comes with a 
limited 5-year warranty so please retain your receipt in a safe place for possible 
future reference; you will need in the event of warranty service. 
 
Sonic Alert, Inc. 
1050 East Maple Rd. 
Troy, MI 48083 
 
V/TTY 1-248-577-5400 fax 248-577-5433 
E-mail: sonic-info@sonicalert.com 
Web Site: www.SonicAlert.com 
REV 1.5 (2008) 
 
 
 
This device complies with Part 15 of the FCC Rules and with RSS-210 
of Industry Canada.  Operation is subject to the following two 
conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including 
interference that may cause undesired operation.
 
WARNING: Changes or modifications not expressively 
approved by the party responsible for compliance could void 
user’s authority to operate the equipment.