ResMed Flow Generator VPAP Adapt SV Manual Do Utilizador

24

This menu displays the following information:

•

SN—the flow generator’s serial number

•

PCB—the flow generator’s PCB number (PCB—printed circuit board)

•

SW—the version of software currently installed on the flow generator.

There are three Treatment screens displayed in the VPAP Adapt SV LCD. The 
LCD will display the Treatment screens when treatment commences, and during 
treatment if no key is pressed for 20 minutes.

Press the QuickView key at any point within a menu to display 
Treatment Screen 1. You can return to your original screen if you press 
the QuickView key again within 20 minutes.

Press the Right key to move from a Treatment screen to the Standby screen.

If an alarm is triggered while you are in the Treatment screens, the arrow will 
flash. Press the Down key until you reach the alarm message.

Scroll through the screens in the usual way, using the Up/Down key.

Figure 16: Treatment Screen 1

Figure 17: Treatment Screen 2

Figure 18: Treatment Screen 3

ASV             5.0--15.0

exit

Treatment mode

Pressure

LK:18L/min       RR:12
                       VT: 428

Leak

Respiratory rate

 

Tidal volume

MV:6.2        TARG:5.8

exit

                 

Minute ventilation

Target ventilation

228234 VPAP Adapt SV User Guide USA Eng.book  Page 24  Monday, October 13, 2008  2:15 PM