Fujitsu DX60 Manual Do Utilizador

Chapter 4  Operations
  4.2  Monitoring ETERNUS DX Disk Storage System Status

ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-

Copyright 2012 FUJITSU LIMITED

P3AM-5512-03ENZ0

4.2

Monitoring ETERNUS DX Disk Storage System 
Status

Check the status of the ETERNUS DX Disk storage system regularly by checking the LEDs or 
the status display function of ETERNUS Web GUI.

In addition, setting event notification enables e-mail notification messages or SNMP Trap 
messages for events with the ETERNUS DX Disk storage system in order to monitor the status 
of the ETERNUS DX Disk storage system.

Each CM has an LED that lights up green to identify when it is the 
Master CM.

Setting the IP address of the Slave CM ensures that ETERNUS Web 
GUI or ETERNUS CLI can be used from the Slave CM if an error occurs 
on the LAN path for the Master CM.
 The Master CM and the Slave CM perform different functions. The 
Slave CM can only switch the Master CM and display the status of the 
ETERNUS DX Disk storage system.
 The IP address of the Slave CM does not need to be set for normal 
operation.

Figure 4.2

LAN control (when the IP address of the Slave CM is set)

Controller enclosure

CM#0

Master
CM

CM#1

Slave
CM

RMT

RMT

ETERNUS DX Disk storage system

LAN path

error

The IP address of the Slave CM is used
to switch the Master CM and display
the status of
the ETERNUS DX Disk storage system.

CAUTION

Impending trouble may be indicated by the warning message FAULT 
LEDs of the ETERNUS DX Disk storage system. The LEDs and the 
general status of ETERNUS Web GUI should be checked regularly to 
prevent any serious trouble from occurring.

Event notification and status display for the ETERNUS DX Disk storage 
system can be performed by ETERNUS CLI. When ETERNUS CLI is used, 
refer to "ETERNUS CLI User's Guide".