Fujitsu DX60 Manual Do Utilizador
Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
5.2 Installing Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
64
Copyright 2012 FUJITSU LIMITED
P3AM-5512-03ENZ0
6
Repeat
and
for each additional disk.
7
Remove the wrist strap.
8
Remove the front cover.
.
9
On the Storage System Status screen of ETERNUS Web GUI, check that the
added disks have been recognized.
added disks have been recognized.
10
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
disks, as required.
End of procedure
5.2
Installing Drive Enclosures
Optional drive enclosures can be installed while the ETERNUS DX Disk storage system is run-
ning without affecting the system.
This section explains how to install optional drive enclosures.
ning without affecting the system.
This section explains how to install optional drive enclosures.
5.2.1
Installation Rules for Drive Enclosures
Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Drive enclosures cannot be connected to 2.5" type controller enclosures.
5.2.2
Installable Drive Enclosures
shows the installable drive enclosures.
Table 5.3
Installable drive enclosures
At time of purchase, the installable drive enclosure model may be different from those described.
To find the web-site to check the latest version of this manual, refer to "Read Me First".
To find the web-site to check the latest version of this manual, refer to "Read Me First".
Model name
Product name
ETEED1DU-L, FTS:ETEED1DU-L
Drive enclosure for DX60 S2 (3.5inch, single-expander type)
ETEED2DU-L, FTS:ETEED2DU-L
Drive enclosure for DX60 S2 (3.5inch, dual-expander type)