Bunn ITB Manual Do Proprietário

OPTIONAL SWEETENER

Connect sweetener line to fitting on back of brewer labeled "SWEETENER".

NOTE: Operating range for sweetener is 25-60psi, 35psi recommended.

CE Requirements:

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specified in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of

this appliance by a person responsible for its safety.

• Children should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel

with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.

• Machine must not be immersed for cleaning.

PLUMBING REQUIREMENTS

These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (138

and 620 kPa) from a 1/2˝ or larger supply line. A shut-off valve should be installed in the line before the brewer.

Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345 kPa).

The water inlet fitting is .75-11.5 NH (HOSE THREAD). For convenience an elbow adaptor is provided to convert

to a 1/4˝ flare fitting (3/8˝ flare on Twins). Bunn-O-Matic does not recommend the use of a reverse-osmosis or

deionized water supply to this equipment. REQUIRED: 1.25 gpm (4.73 lpm) flow rate from water supply line.

NOTE - Bunn-O-Matic recommends 3⁄8" copper tubing for all installations from the 1⁄2" water supply line. A tight

coil of tubing in the water line will facilitate moving the brewer to clean the counter top. Bunn-O-Matic does not

recommend the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply

line by this type of device may restrict water flow.

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual

of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow pre-

vention to comply with federal, state and local codes. For models installed outside the U.S.A., you must

comply with the applicable Plumbing /Sanitation Code for your area.

Plumbing Hook-Up

1. Remove the shipping cap from the fitting on the rear of the brewer.

2. STANDARD MODELS: Securely attach adaptor elbow assembly to the .75-11.5 NH (HOSE THREAD) fit-

ting at the rear of the brewer.

TWIN MODELS: Securely attach the tube assembly (supplied in parts box) to water supply line. Securely

attach the elbow assemblie to the .75-11.5 NH (HOSE THREAD) fittings at the rear of the brewer. Connect the

tube assembly to the elbows.

3. Flush the water line and Securely attach it to the adaptor elbow.

4. Turn on the water supply.

36748.3 062111