Vinotemp VT - IMSW Manual Do Utilizador

9

 

 
 

1 7 6 2 1   S o u t h   S u s a n a   R o a d ,   R a n c h o   D o m i n g u e z ,   C a l i f o r n i a   9 0 2 2 1  

i n f o @ v i n o t e m p . c o m  

 

 
You can solve many common problems easily, saving you the cost of a possible service call. 
Try the suggestions below to see if you can solve the problem before contacting Vinotemp. 

Ice maker does not power 
on 

•  Not plugged in. 

•  A tripped circuit breaker or a blown fuse. 

•  Ice maker control switch is set in “OFF” position. 

Ice maker is on but not 
producing ice 

•  Airflow to front grill is blocked 

•  Ice maker arm was set in the “OFF” position 

•  Water supply is turned off 

•  Water line is crimped; water is not reaching unit 

•  Ice maker has excessive frost build up 

Compressor turns on and 
off frequently 

•  Room temperature is warmer than normal. 

•  Appliance door is open too often. 

•  Door is not closed completely. 

•  Door gasket does not seal properly. 

•  Ice maker does not have adequate ventilation. Check 

to ensure that the grill is unobstructed and condenser 
coils are clean. 

Excessive vibrations 

•  Check to assure that the ice maker is level. Adjust the 

leveling legs as needed. 

Ice maker seems to make 
too much noise 

•  A rattling noise may come from the flow of the 

refrigerant; this is normal. 

•  As each cycle ends, you may hear gurgling sounds 

caused by the flow of refrigerant in your appliance. 

•  Contraction and expansion of the inside walls may 

cause popping and crackling noises. 

•  Ice maker is not level. 

Door will not close properly  •  Ice maker is not leveled. 

•  Door was reversed and not properly installed. 

•  Door gasket is dirty. 

•  The ice bucket is out of proper position. 

Ice cubes are melted 
together 

•  Ice maker door is opened too often