Fire Magic 328841X Instrução De Instalação
TABLE OF CONTENTS
PRODUCT DATA TABLE
CAUTION
Table 1 - Product data table
*Note: If using an insulating liner,
consult liner instructions for
counter cut-out dimensions.
counter cut-out dimensions.
Height
Width
Depth
Fig. 3-1
Do not strike or scrape the ceramic portion of the burner(s) with hard tools, as the material may crack,
chip, or break. Prevent any grease, water, or other foreign material from getting into the ceramic portion of
the burner(s), especially when cold. Always wait for the burner(s) to heat up to a well-distributed red glow
before placing food on the cooking grid. When a burner is hot, it will vaporize small amounts of grease
that drip on it. Always cover the burner(s) when not in use. Keeping the ceramic portion of the burner(s)
free of foreign substances will allow the gas to circulate and burn over the entire heating surface, allowing
for powerful and even cooking over the life of the burner(s).
chip, or break. Prevent any grease, water, or other foreign material from getting into the ceramic portion of
the burner(s), especially when cold. Always wait for the burner(s) to heat up to a well-distributed red glow
before placing food on the cooking grid. When a burner is hot, it will vaporize small amounts of grease
that drip on it. Always cover the burner(s) when not in use. Keeping the ceramic portion of the burner(s)
free of foreign substances will allow the gas to circulate and burn over the entire heating surface, allowing
for powerful and even cooking over the life of the burner(s).
3
L-C2-379
Rev 1 - 1401131355
Specifi cation
Value
Counter opening height*
12"
Counter opening width*
19"
Counter opening depth*
18-
3/
4
"
Main burner
BTU per burner
16,500
Natural-gas orifi ce
#49
Propane-gas orifi ce
#56
1
SAFETY WARNINGS & CODES
3
TABLE OF CONTENTS
3 CAUTION
3 PRODUCT
3 PRODUCT
DATA
TABLE
4 PARTS
LIST
5
PLANNING FOR INSTALLATION OF THE SEARING STATION
5
WHERE TO INSTALL THE SEARING STATION
5
ENSURING PROPER COMBUSTION AIR AND COOLING AIRFLOW
5 EXHAUST
REMOVAL
6 INSTALLATION
6
6
GAS-SUPPLY PLUMBING REQUIREMENTS
6
CHECKING FUEL AND ORIFICES
7 CONVERTING
THE
REGULATOR
7
CONNECTING THE GAS SUPPLY
7
POWER SUPPLY FOR IGNITION AND LIGHTED KNOBS
10
POWER SUPPLY (MULTIPLE ACCESSORY UNITS)
11 GENERAL
INFORMATION
11
SAFETY TIPS IN USING THE SEARING STATION
11
CARE AND CLEANING
11 FLAME
PATTERN
11
SEARING STATION FLAME PATTERN
13
SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS
15
LIGHTING (IGNITION) INSTRUCTIONS
15
SHUTTING OFF THE UNIT
16 WARRANTY