GE GTD86ESPJMC Manual Do Proprietário

Properly ground dryer to conform with all governing codes

and ordinances. Follow details in Installation Instructions.

Install or store where it will not be exposed to temperatures

below freezing or exposed to the weather.

Connect to a properly rated, protected and sized power

supply circuit to avoid electrical overload.

Remove all sharp packing items and dispose of all shipping

materials properly.

Remove the colored protective tape from the control panel.

Do not obstruct the flow of ventilating air. Do not stack or

place laundry or throw rugs against the front or back of the

dryer.

Steam Water Hoses:

GE strongly recommends the use of factory specified parts.

A list of factory hoses available for purchase are listed

below. These hoses are manufactured and tested to meet

GE specifications.

GE strongly recommends the use of new water supply

hoses. Hoses degrade over time and need to be replaced

every 5 years to reduce the risk of hose failures and water

damage.

Parts and Accessories

Order on-line at GEApplianceparts.com today, 24 hours a

day or by phone at 800.626.2002 during normal business hours.

Part Number

Accessory

WE25M53

Complete Kit (hoses, Y-adapter

washers)

(included)

WE1M847

Long hose and

WE1M849

Y-adapter

PM14X10056

Dryer door opening vent brush

(not

included)

WX14X10007

LintEater™ dryer rotary tube brush

(not

included)

Exhaust/Ducting:

All dryers MUST be exhausted to the outside to prevent

large amounts of moisture and lint from being blown into

the room.

Use only rigid metal 4ļ diameter ductwork inside the dryer

cabinet and use only rigid metal 4ļ diameter or UL

approved transition ducting between the dryer and the

home duct. USE OF PLASTIC OR OTHER COMBUSTIBLE

DUCTWORK CAN CAUSE A FIRE. PUNCTURED DUCTWORK

CAN CAUSE A FIRE IF IT COLLAPSES OR BECOMES

OTHERWISE RESTRICTED IN USE OR DURING

INSTALLATION.

For complete details, follow the Installation Instructions.

SAVE THESE INSTRUCTIONS

GEAppliances.com

PROPER INSTALLATION

This dryer must be properly installed and located in accordance with the Installation Instructions before it is used.

If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or by calling

800.GE.CARES (800.432.2737).

ADDITIONAL GAS DRYER WARNINGS

For your safety, the information in this manual must be followed to minimize the risk of fire or explosion

or to prevent damage, personal injury, or death.

- DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:

•  DO NOT try to light any appliance.
•  DO NOT touch any electrical switch; DO NOT use any phone in your building.
•  Clear the room, building, or area of any occupants.
•  Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•  If you cannot reach your gas supplier, call the fire department.

- Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

WARNING

State of California Proposition 65 Warnings:

The California Safe Drinking Water and Toxic Enforcement Act requires the governor of California to publish a list of substances

known to the state to cause cancer, birth defects or other reproductive harm and requires businesses to warn of potential exposure

to such substances.

WARNING

This product contains one or more chemicals known to the State of California to cause cancer, birth defects or

other reproductive harm.

Gas appliances can cause low-level exposure to some of these substances, including benzene, carbon monoxide, formaldehyde and

soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Exposure to these substances can be minimized by

properly venting the dryer to the outdoors.