Samsung WA56H9000A Guia De Informação

1

5E

The water level fails to drop below

the Reset Water Level within 30

minutes.

Go to “ Will Not Drain”

Troubleshooting Section.

2

dE1

Door fails to Unlock / lock After 7

attempts.

Go to “ Will Not Unlock / Lock”

Troubleshooting Section.

3

4E

When the filling continues for more

than 60 minutes or there is no

change of water level for 5 minutes.

Go to “ No Water Fill”

Troubleshooting Section.

4

LE

A water level lower than the Reset

water level is detected for 5 seconds

during the Wash/Rinse cycle.

Go to “No Water Fill” Troubleshooting

Section.

5

1E

Water Level Sensor Trouble. (When

the input signal from the water level

sensor is out of range, the unit will

send out beeping sounds and halts

the cycle.)

Go to “No Water Fill”

Troubleshooting Section.

6

OE

A fault is detected in the water level

sensor. Data (frequency) shows

the water level is at or above the

overflow water level. (When this

condition is detected, the machine

will automatically start draining

water until the water level falls

below the reset water level.)

First check to see that all of water

valves are not stuck. If the water

valves are OK, check water level.

7

UE

Unbalance or cabinet bump is

detected during final spin.

Go to “Wet Clothes” Troubleshooting

Section.

8

dE

Door is detected as open while it is

trying to lock the door.

Go to “Quick Test Mode” and then do

Door Lock/Unlock Test.

9

tE

This occurs when the water

temperature sensor fault is detected

continuously for 5 seconds.

Go to “ Board Input Test” and check

Water Temperature. Check loose

or pinched wires. Replace PCB or

thermistor.

10

3E

MICOM is attempting to drive the motor

but is not getting any response signals

from the hall sensor. Visual check shows

motor is not running. (Locked, Defective

Hall Sensor or Overload.)

Evaluate wire harness for loose or

unhooked connections. Go to “

Quick Test Mode” and test Motor.

11

4E

The hot/cold water hose connection

is not correct.

Please connect the hot/cold water

hose connection correctly.

To avoid risk of electrical shock, personal injury or death; disconnect power to washer

before servicing, unless testing requires power.

WA9000HA WASH_WA56H_TECH MANUAL_DC68-03132F_EN.indd   2

2014-1-22   9:18:19