Viking RVRF336SS Utilização E Cuidado

10

Removing the Doors

Once both doors are in place, ensure they are aligned with 
each other and level (please see the “Installation” section for 
more details), and replace the top hinge cover.

CAUTION

Be sure doors are set aside in a secure position 
where they cannot fall and cause personal injury, or 
damage to the doors or handles.

To remove the refrigerator doors:

 

1

  Trace lightly around the door’s top hinges with a 

pencil. This makes reinstallation easier.

 

2

  Disconnect the harness by grasping both sides of the 

connector fi rmly, depress the latch, and pull apart. 
Remove the two screws from the top hinge. Lift the 
door off of the bottom hinge and set it aside.

 

3

  Unscrew the three lower hinge screws and hinge if 

Lower Hinge Removal

necessary.

Getting through narrow spaces 

If your refrigerator will not fi t through an entrance area, 
before installing the door handles, you can remove the 
doors. Check fi rst by measuring the entrance.

To prepare for removing the doors:

 

1

  Make sure the electrical power cord is unplugged 

from the wall outlet.

 

2

  Open the freezer drawer and remove the toe grille 

(see “Installation” section).

 

3

  Remove any food from the door shelves and close the 

doors.

To remove the top hinge covers:

 

1

  Remove the two screws from each cover over the top 

door hinges.

 

2

  Lift inside edge of hinge cover and tilt back.

NOTE

DO NOT remove the ground screw from hinge.

Removing Freezer Drawer

 

1

  Open freezer drawer.

 

2

  Remove drawer screws on right and left sides (two 

screws on each side).

 

3

  Lift drawer up and out to remove.

Remove Hex
Head drawer
Screw

Remove Hex
Head drawer
Screw

Remove Hex
Head drawer

Screw

Remove Hex
Head drawer

Screw

DO NOT REMOVE
OTHER SCREWS

To reinstall the right door, reverse the above steps.