Whirlpool CSP2861TQ Instrução De Instalação

You can install the 30-minute or 60-minute timing cam  

(shipped with dryer) as follows:
1.  Unplug dryer or disconnect power.
2.  Unlock control panel. Lift up and rotate out from cabinet. 

Control panel will still be attached to cabinet.

3.  Use a Phillips screwdriver to loosen (but not remove) timer 

mounting bracket screw. Lift up to remove timer assembly 

and bracket from cabinet.

4.  Turn the timing cam by hand until the V-shaped notch lines 

up below the ratchet tooth.

5.  Insert a narrow, flat-blade screwdriver under the timing cam 

near the clock shaft. Gently lift cam straight up and off shaft, 

making sure that the V-shaped notch clears the ratchet tooth.

6.  Place new cam (hub side down) over clock shaft. Line up flat 

side of shaft with flat side of cam hole. Check that drive lug 

is in place.

7.  Turn cam until V-shaped notch lines up with ratchet tooth.

8.  Press cam down in place on clock shaft. Make sure that 

V-shaped notch clears the ratchet tooth.

9.  Reattach the timer bracket assembly; then tighten  

the screws.

10.  Repeat steps for the other timer.
11. Close and lock the control panel.
12. Plug in dryer or reconnect power.