Frigidaire FPEF3077QF Instrução De Instalação

2

  

 If the information in this manual is not followed 

exactly, a fire or electrical shock may result causing property 
damage, personal injury or death.

Range 

leveling leg

Anti-tip 

bracket

To check if the anti-tip bracket is installed properly, use 

both arms to grasp the rear edge of the range back. 

Carefully attempt to tilt range forward. When properly 

installed, the range should not tilt forward.

Refer to the anti-tip bracket installation instructions 

supplied with your range for proper installation.

1.  Read all instructions contained in these installation 

instructions before installing range.

2.  Remove all packing material from the oven compartments 

before connecting the gas and electrical supply to the 

range.

3.  Observe all governing codes and ordinances.

4.  Be sure to leave these instructions with the consumer.

Keep these instructions with your owner's guide for  future 

reference.

•  As when using any appliance generating heat, there are 

certain safety precautions you should follow. These are 

listed in the Use & Care Manual, read it carefully.

•  Be sure your range is installed and grounded properly 

by a qualified installer or service technician.

•  Make sure the wall coverings around the range can 

withstand the heat generated by the range.

•  To eliminate the need to reach over the surface elements, 

cabinet storage space above the elements should be 

avoided.

• 

Adjustable wrench or channel lock pliers 

• 

5/16" (21 mm) Nutdriver or Flat Head Screwdriver 

•  Electric Drill & 1/8" (3 mm) Diameter Drill Bit (Masonry 

Drill Bit if installing in concrete)

•  1/4" (6 mm) & 3/8" (10 mm) Socket driver or Nutdriver 

•  Copper Electrical Wiring & Metal Conduit (for hard wiring)

To reduce the risk of tipping of the range, the range should 

be secured to the floor by properly installed anti-tip bracket 

and screws packed with the range. Failure to install the 

anti-tip bracket will allow the range to tip over if excessive 

weight is placed on an open door or if a child climbs upon 

it. Serious injury might result from spilled hot liquids or from 

the range itself.

 

If  range  is  ever  moved  to  a  different  location,  the  anti-tip 

brackets must also be moved and installed with the range. 

 

Instructions are provided for installation in wood or cement 

fastened to either the floor or wall.  When installed to the 

wall, make sure that screws completely penetrate dry wall 

and are secured in wood or metal.  When fastening to the 

floor or wall, be sure that screws do not penetrate electrical 

wiring or plumbing.
A.  Locate the Bracket Using the Template - (Bracket may 

be located on either the left or right side of the range.  Use 

the information below to locate the bracket if template is 

not available).  Mark the floor or wall where left or right 

side of the range will be located.  If rear of range is against 

the wall or no further than 1-1/4" (32 mm) from wall when 

installed, you may use the wall or floor mount method. If 

molding is installed and does not allow the bracket to fit 

flush against the wall, remove molding or mount bracket 

to the floor. For wall mount, locate the bracket by placing 

the back edge of the template against the rear wall and 

the side edge of template on the mark made referencing 

the side of the range. Place bracket on top of template 

and mark location of the screw holes in wall.  If rear of 

range is further than 1-1/4" (32 mm) from the wall when 

installed, attach bracket to the floor.  For floor mount, 

locate the bracket by placing back edge of the template 

where the rear of the range will be located.  Mark the