Raymarine DS400 & DS500 Manual Do Utilizador
16
DS400 and DS500 Digital Fishfinders
2.7 Installing the E66062 (P58) Transducer
Please use the following installation instructions if your fishfinder is
equipped with a E66062 (P58) Multisensor Transom Mount Transducer.
Installation instructions for other transducer models are included with the
transducer.
equipped with a E66062 (P58) Multisensor Transom Mount Transducer.
Installation instructions for other transducer models are included with the
transducer.
Please read these instructions completely before proceeding with the
installation.
installation.
CAUTION: NEVER USE SOLVENTS
Cleaners, fuel, paint, sealants, and other products may contain strong
solvents, such as acetone, which attack many plastics greatly reducing
their strength.
Cleaners, fuel, paint, sealants, and other products may contain strong
solvents, such as acetone, which attack many plastics greatly reducing
their strength.
Applications
•
Not recommended for boats with large or twin screw inboard engine(s)
•
Requires 89mm (3-1/2") of headroom to install
•
Good operation up to 44kts (50MPH)
•
Vertically orients sound beam on hull with deadrise angle up to 30°
•
Adjusts to transom angles from 2
°–22°
•
Bracket protects multisensor from frontal impact only
Tools and Materials
Screwdrivers
Pencil
Safety goggles
Dust mask
Electric drill
Drill bits:
Bracket holes
4mm, #23, or 9/64"
Fiberglass hull
chamfer, countersink, 6mm, or 1/4"
Transom hole (optional)
18mm, 11/16", or 3/4"
Cable clamp holes
3mm or 1/8"
Masking tape
Marine sealant
Straight edge
Zip-ties
Water-based antifouling paint (mandatory in salt water)