Vertex Standard FT-950 Manual Do Utilizador

 

FT-950 

Operating Manual 

Vertex Standard Co., Ltd. 

116

bands. On the 10/14 MHz bands, “FINE” [SELECT(µ-TUNE)] knob steps will 
be used (1 step/click). 

StP2: 

Activates the µ-TUNE system using “FINE” steps of the [SELECT(µ-TUNE)] 
knob (1 step/click) on the 14 MHz and lower amateur bands. 

Advice: If an optional RF µTuning Kit is not connected, this adjustment has no effect. 
 
033 GENE MIC SCN 
Function: Enables/disables scanning access via the microphone’s [UP]/[DWN] keys. 
Available Values: On/OFF 
Default Setting: On 
 
034 GENE SCN RSM 
Function: Selects the Scan Resume mode. 
Available Values: CAr/5SEc 
Default Setting: 5SEc 
CAr: 

The scanner will hold until the signal disappears, then will resume after one 
second. 

5SEc:  The scanner will hold for five seconds, then resume whether or not the other 

station is still transmitting. 

 
035 GENE FRQ ADJ 
Function: Adjusts the reference oscillator. 
Available Values: –25 ~ 0 ~ +25 
Default Setting: 0 
Connect a 50-Ohm dummy load and frequency counter to the antenna jack; adjust the 
[CLAR/VFO-B] knob so that the frequency counter reading is same as the VFO 
frequency while pressing the PTT switch. 
Advice: Do not perform this Menu item unless you have a high-performance frequency 
counter. Perform this Menu item after aging the transceiver and frequency counter 
sufficiently (at least 30 minutes). 
 
 
MODE-AM Group 
036 A3E MICGAIN 
Function: Sets the microphone gain for the AM mode. 
Available Values: Ur/0 ~ 100