Vertex Standard FT-950 Manual Do Utilizador
FT-950
Operating Manual
Vertex Standard Co., Ltd.
27
FUNCTION Switch EFFECT
[(VFO-B)RX]
Indicator/Switch
[(VFO-B)RX]
Indicator/Switch
Rotate this knob to adjust the VFO-B frequency by a same step
as the Main Tuning Dial knob.
The frequency display will be changed to the VFO-B frequency.
as the Main Tuning Dial knob.
The frequency display will be changed to the VFO-B frequency.
[BAND] button
Rotate this knob to select the amateur band.
[GRP] button
Rotate this knob to select the CONTOUR filter response.
The peak position of the CONTOUR filter can be observed on
the display.
The peak position of the CONTOUR filter can be observed on
the display.
[MHz] button
Rotate this knob to tune the VFO frequency in 1 MHz step.
[MCH] button
Rotate this knob to select the memory channel.
Display Indications
1. PROC
This indicator appears whenever the DSP Speech Processor is activated.
2. MONI
This indicator appears whenever the transmit monitor circuit is activated.
3. KEYER
This indicator appears whenever the internal CW keyer is activated.
4. BK-IN
This indicator appears whenever CW break-in operation is activated.
5. NB
This indicator appears when the receiver’s “short-duration” Noise Blanker is activated.
This indicator will blink for three seconds, and thereafter appears continuously, when
the receiver’s “longer-pulse” Noise Blanker is activated.
6. NAR
This indicator appears whenever the receiver’s narrow IF DSP filter is engaged.
7. S/PO
Indicates the received signal strength, from S-0 to S-9+60dB on receiving.
Indicates the RF Power Output, from 0 to 150 Watts on transmit.
Advice: The S and PO meters can be provided the Peak-hold function via the Menu
item “007 DISP PKH S” and “008 DISP PKH PO”.
This indicator appears whenever the DSP Speech Processor is activated.
2. MONI
This indicator appears whenever the transmit monitor circuit is activated.
3. KEYER
This indicator appears whenever the internal CW keyer is activated.
4. BK-IN
This indicator appears whenever CW break-in operation is activated.
5. NB
This indicator appears when the receiver’s “short-duration” Noise Blanker is activated.
This indicator will blink for three seconds, and thereafter appears continuously, when
the receiver’s “longer-pulse” Noise Blanker is activated.
6. NAR
This indicator appears whenever the receiver’s narrow IF DSP filter is engaged.
7. S/PO
Indicates the received signal strength, from S-0 to S-9+60dB on receiving.
Indicates the RF Power Output, from 0 to 150 Watts on transmit.
Advice: The S and PO meters can be provided the Peak-hold function via the Menu
item “007 DISP PKH S” and “008 DISP PKH PO”.