KitchenAid KDRU763.KDRU Manual Do Proprietário

7. Once the self-clean setup function is complete, the Start key 

will light up.

8. When settings are correct, touch START.

9. Once the Start key is touched, the Delayed Self-Clean will be 

displayed showing the settings. A countdown timer will be 
displayed in the lower left hand portion of the display 
showing the time remaining until self-cleaning begins.

10. When the start time is reached, the oven will automatically 

turn on. The countdown timer will appear on the oven display. 
If the door is opened before the self-clean cycle begins, the 
self-clean cycle will be canceled and a message will appear. 
Touch OK to return to the Main Menu.

11. When the end of the self-clean time is reached, the oven will 

shut off automatically and the Complete message will be 
displayed. If enabled, end-of-cycle tones will sound, then 
reminder tones will sound every minute. Touch OK to clear 
this message, stop reminder tones and return to the Main 
Menu

Once the self-clean cycle starts, the door will automatically lock 
and “DOOR LOCKED” will appear on the display.

The door will not unlock until the oven cools and the Complete 
message appears.

Touch OFF. If the oven temperature is too high, the door will 
remain locked. It will not unlock until the oven cools.

Water filter cartridge should be replaced when “REPLACE 
FILTER” appears in the control panel display, or after 1 year of 
use. 

For further information or to order a replacement water filter 
cartridge, visit www.whirlpool.com or call 1-866-986-3223. Ask 
for Part Number 8212695. 

Turn filter cartridge to the left to remove cartridge from the filter 
head. 

Install new cartridge. Turn cartridge to the right to reattach to the 
filter head.

Please reference the “Assistance or Service” section.

IMPORTANT: Before cleaning, make sure all controls are off and 
the oven is cool. Always follow label instructions on cleaning 
products.

Soap, water and a soft cloth or sponge are suggested first unless 
otherwise noted.

STAINLESS STEEL (on some models)

Do not use soap-filled scouring pads, abrasive cleaners, Cooktop 
Polishing Creme, steel-wool pads, gritty washcloths or abrasive 
paper towels. Damage may occur, even with one-time or limited 
use.

Rub in direction of grain to avoid damaging.

■

KitchenAid

®

 Stainless Steel Cleaner and Polish Part Number 

4396920 (not included) or KitchenAid

®

 Stainless Steel Wipes 

Part Number 8212510 (not included):

See “Assistance or Service” section to order.

■

Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

Food spills containing acids, such as vinegar and tomato, should 
be cleaned as soon as the cooktop, grates and caps are cool. 
These spills may affect the finish.

To avoid chipping, do not bang grates and caps against each 
other or hard surfaces such as cast iron cookware.

Do not reassemble caps on burners while wet.

Do not clean in the Self-Cleaning cycle.

Do not clean in dishwasher.

■

Nonabrasive nylon scrub pad and mildly abrasive cleanser:

Clean as soon as cooktop, grates and caps are cool.

See “Sealed Surface Burners” section.

To avoid damage to the cooktop controls, do not use steel wool, 
abrasive cleansers or oven cleaner.

To avoid damage, do not soak knobs. 

When replacing knobs, make sure knobs are in the Off position.

Do not remove seals under knobs.

NOTE: When replacing knobs after cleaning either the surface 
burner controls or the griddle module control, make sure the 
knobs are replaced to the correct location. The 20,000 Btu/h 
burner knobs have power settings and the griddle knob has 
temperature settings. All other knobs have Hi, Med, Lo settings 
only.

■

Warm, soapy water:

Pull knobs straight away from control panel to remove.