KitchenAid 2266877 Manual Do Utilizador

If built-in area depth is 25 in. (63.5 cm) or more, side panels can 
be installed inside the side trim or attached to the outside of the 
side trim. 

1. For inside side trim piece, slide front edge of routed side 

panel into trim piece. 

2. Nail rear edge of panel to support board.  

IMPORTANT: KitchenAid is not responsible for the removal or 
addition of molding or decorative panels that would prevent the 
refrigerator from being serviced.

1. Remove base grille, skirt and two screws from package taped 

to front of refrigerator.

2. Open refrigerator door and measure the distance from the 

bottom of refrigerator cabinet to the floor.

3. Measure this same distance from the top of the bottom grille 

to the closest “V” groove on the grille skirt. Use a knife to 
score down the “V” groove and break skirt at the score line.

4. Slide skirt assembly onto bottom grille. 

5. Attach the bottom grille and skirt assembly to the cabinet 

with the two screws.

1. Turn water supply line valve to “Open” position. 

2. Turn refrigerator switch to ON position. Wait a few minutes. 

Check water line connections for leaks. 

3. Open appliance doors and remove all boxes, parts packages 

and packing materials. See the “Cleaning” section in the Use 
and Care Guide for instructions. Remove protective film from 
door frame.

4. Install shelves and bins in refrigerator and freezer 

compartments.

5. Set refrigerator and freezer compartment controls to the 

midpoint setting. Check that the compressor is operating 
properly and that all lights are working.

6. Flush water system before using. See the “Water System 

Prep” section in the Use and Care Guide. 

NOTE: If construction will continue after refrigerator has been 
installed, set controls to OFF.

To get the most efficient use from your new built-in refrigerator, 
read your Use and Care Guide. Keep Installation Instructions and 
Guide near the built-in refrigerator for easy reference.