RTS ADAM Manual Do Utilizador
32
Test Button
The Test button is used to test the frame mapping configuration you create. Once you have tested your frame map
configuration, press the Apply button to implement the modifications you make. The message below appears if the frame map
is deemed valid.
configuration, press the Apply button to implement the modifications you make. The message below appears if the frame map
is deemed valid.
Done Button
The Done button is used to close the Frame Mapping window.
Select Frame Window
The Select Frame window, shown in Figure 46, is used to select a Frame (IP Address and MAC Address) to include in the
Frame Mapping table for your Tribus Intercom System.
Frame Mapping table for your Tribus Intercom System.
IP Address 1 Column
The IP Address 1 column displays the IP Address of the active master controller in the ADAM frame.
FIGURE 45.
Frame Mapping Table Valid message
FIGURE 46.
Select Frame Window