Banner American Products MIGHTYLAM 2700 Manual Do Utilizador

TROUBLESHOOTING

PROBLEM:

Laminator is inoperative. Motor does not run, indicator lights are out.

ACTION:

Unit may be unplugged. Connect power supply. Ensure that your circuit breaker has

not tripped. Fuse may have blown. Replace 15 amp power fuse.

PROBLEM:

Laminating film and item being laminated move through laminator erratically.

ACTION:

Check thickness of item to be laminated. Maximum thickness is 1/16” (1.6mm) if

              rollers have not been adjusted. Clean heat shoes of residual adhesive. Refer to
              MAINTENANCE section for cleaning instructions.

PROBLEM:   Plastic is not bonding to the item or to itself at the edges.

ACTION:

Make sure heat shoes and rollers are at proper operating temperature and have had time to warm up

(Approximately 30 minutes). See table 1 for the suggested

temperature ranges.

PROBLEM:

Wrinkles appear on the laminated items running parallel with the outside edges.

ACTION:

Increase film tension on top and/or bottom supply rolls. Reduce heat shoe

temperature. Clean heat shoes of residual adhesive. See MAINTENANCE section

for cleaning instruct

ions.

PROBLEM:

Blistering of the film appears over the item or along the edge.

ACTION:

Reduce temperature on one or both heat shoes. If the indicator light remains on after

the adjustment is made, disconnect the power supply and contact your dealer. Clean laminating

rollers. See MAINTENANCE section for cleaning instructions. There may be moisture in the

paper you are laminating. Store paper in a dry place and be sure that any ink is thoroughly dry before

laminating.

PROBLEM:

Laminated material curls after leaving pull rollers.

ACTION:

Adjust tension. If laminated item curls upwards, reduce top roller film. If item curls downward, reduce

bottom film tension. Clean heat shoes of residual adhesives as it may be causing “drag” on one side.

Refer to MAINTENANCE section for cleaning instructions.