Precor EC860 Manual Do Utilizador
page 16
Designing a Customized Course
The EC860 Professional Recumbent Cycle lets you design two custom courses:
program “8” and program “9.” To access these courses, you need to press a
specific combination of keys on the electronic console. This design helps
secure the cycle from unauthorized access and changes.
program “8” and program “9.” To access these courses, you need to press a
specific combination of keys on the electronic console. This design helps
secure the cycle from unauthorized access and changes.
To design a custom course, take the following steps:
1.
Check that the cycle is turned ON. If it is turned OFF, turn it ON using the
ON/OFF power switch. This switch is located on the front of the cycle, near
the power cord.
ON/OFF power switch. This switch is located on the front of the cycle, near
the power cord.
2.
Press the ON key. The initial start-up prompt, “Choose Workout Program”
appears.
appears.
Note: If the cycle is already ON and EC860 is scrolling across the bottom of
the display. You can start pedaling, press the
the display. You can start pedaling, press the
and
keys, or press
ENTER/RESET and the initial start-up prompt, “Choose Workout Pro-
gram” will appear.
gram” will appear.
3.
Access the User Programming screen by simultaneously pressing and
holding ON and
holding ON and
for a minimum of 5 seconds.
4.
Release both keys when you see the User Programming screen. In the
upper left-hand window, “User Program 1” will be highlighted as shown in
Diagram 4.
upper left-hand window, “User Program 1” will be highlighted as shown in
Diagram 4.
Note: User Program 1 represents program 8 and User Program 2 repre-
sents program 9.
sents program 9.
Diagram 4
User Programming screen