Vidikron Model 85 Manual Do Utilizador

Select HD/RGB Adj. from the Main Menu to view input signal resolution and timing 
information. 

Signal Info: Select Signal Info from the HD/RGB Adj. menu to display the resolution, 
horizontal frequency and vertical frequency of the input current signal. 

Select Options from the Main Menu to perform the following projector configuration tasks.

Image Shift: Select Image Shift from the Options menu to vertically shift the projected 
image. 

Subtitle: Select Subtitle from the Options menu to adjust the projected image height in 
small increments. 

 

Overscan: Refer to Overscan on page 55.

Default: To reset the Overscan setting to its default value, select Default from the Options 
menu, then select Yes to confirm the reset. 

LED: Select LED from the Options menu to change the behavior of the projector’s indicator 
LEDs. 

• When set to ON, the LEDs indicate operating status as described in Vision 85 at a Glance 

 

• When set to OFF, the LEDs illuminate when the Vision 85 is in standby mode, warming up 

or indicating an error condition; otherwise, they are off. 

Lamp Hours (read-only): Refer to Lamp Hours on page 61. 

OSD: When you select an aspect ratio or input with the remote control (or from the VHD 
Controller), the Vision 85 displays your selection on-screen. To prevent the display of these 
items, select OSD from the Options menu and set it to Off. 

When you set the Auto Power Off function (refer to Power Save, below) to 
Off, the LED function is automatically set to On.