VBrick Systems EtherneTV-NXG 2 Manual Do Utilizador

V B R I C K   E T H E R N E T - N X G   V O D   Q U I C K   S T A R T   G U I D E    

V E R S I O N   2 . 0 . 0 E  

C O P Y R I G H T   V B R I C K   S Y S T E M S  

P A G E   4  

J U N E   2 3 ,   2 0 0 4  

Quick Start  

1.  Unpack the EtherneTV-NXG1 Server.    

Each shipment comes with: 

•  An introduction letter 
•  Quick Start Guide and Release Notes (located on CD-ROM 8250-0002-0000) 
• (1) 

EtherneTV-NXG 

system 

• Power 

cord 

•  Rack mount kit (Kit type must be specified) 
•  Recovery CDs and a floppy disk that contains the NXG license (do not lose) 

 
NOTE:  The server comes preloaded with the Operating System and VOD application 
software. After the system is powered, a kick-start wizard will guide you through the initial 
setup for permanent operation.  

Make sure that there is: 

•  A separate PC running Internet Explorer  
• PS/2 

mouse 

• Keyboard 
•  Monitor or console   

 
NOTE: If you have purchased an external storage device such as a SCSI attached DAS 
it must be connected prior to powering up the NXG system. 
 
Please obtain the following information for the EtherneTV-NXG before applying power to the 
unit:  

NOTE:  Unix commands are case sensitive and should be entered as shown.  

 

 

 

 

 

 

 

 

 

Hostname (that will be assigned to EtherneTV 
VOD) 

 vbvodnxg 

EtherneTV VOD IP address 

 

172.17.6.55 

Default gateway (router) 

 

172.17.1.5 

System network netmask 

 

255.255.0.0 

Broadcast IP address 

 

172.17.255.255 

Default network IP address 

 

172.17.0.0 

Domain name 

 

vb.loc 

DNS IP address 

 

64.80.0.162 

EtherneTV VOD serial number (from back of unit) 

 

unused at this time 

Server name (Not Applicable) 

 

 unused?