Runco LS-1 Manual Do Utilizador
Runco LS-1 Installation/Operation Manual
1
PRE
L
IMINAR
1.1
About This Manual
About This Manual
This Owner’s Manual describes how to install, set up and operate the Runco LS-1 Digital
Light Processing (DLP™) Projector.
Light Processing (DLP™) Projector.
Throughout this manual, the Runco LightStyle™ Series LS-1 Home Theater Projector is
referred to as the “LS-1.”
referred to as the “LS-1.”
Target Audience
Runco has prepared this manual to help home theater installers and end users get the
most out of the LS-1.
most out of the LS-1.
If You Have Comments
About This Manual...
About This Manual...
Runco welcomes your comments about this manual. Send them to info@Runco.com.
Textual and Graphic
Conventions
Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify
the information and instructions provided:
the information and instructions provided:
• Remote and built-in keypad button identifiers are set in upper-case bold type; for
example, “Press EXIT to return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type op aspect = 1 <Enter>. ”
Letterbox, type op aspect = 1 <Enter>. ”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following: <Enter>, <Spacebar>, <Control>,
<Esc>
<Esc>
and <Tab>.
• <Enter> indicates that you may press either the RETURN or ENTER key on your
keyboard if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used
to highlight important information, as in this example:
to highlight important information, as in this example:
1. Introduction
A carriage return must be used after each command or string.
Note