Vertex Standard FT-60R Manual Do Utilizador
FT-60R O
PERATING
M
ANUAL
20
M
ANUAL
R
EPEATER
S
HIFT
A
CTIVATION
If the ARS feature has been disabled, or if you need to set a repeater shift direction other
than that established by the ARS, you may set the direction of the repeater shift manually.
than that established by the ARS, you may set the direction of the repeater shift manually.
To do this:
1.
1.
Press the [F/W] key, then press the [0(
)SET] key to enter the Set mode.
2.
Rotate the DIAL knob to select Set Mode Item 38: RPT.MOD.
3.
Press the [F/W] key momentarily to enable adjustment of this
Item.
Item.
4.
Rotate the DIAL knob to select the desired shift among “RPT.–,”
“RPT.+,” and “RPT.OFF.”
“RPT.+,” and “RPT.OFF.”
5.
When you have made your selection, press the PTT switch to
save the new setting and return to normal operation.
save the new setting and return to normal operation.
If you make a change in the shift direction, but still have Automatic Repeater
Shift still engaged (see previous section), when you change frequency (by
rotating the DIAL knob, for example) the ARS will over-ride your manual
Shift still engaged (see previous section), when you change frequency (by
rotating the DIAL knob, for example) the ARS will over-ride your manual
setting of the shift direction. Turn ARS off if you do not wish this to happen.
Changing the Default Repeater Shifts
If you travel to a different region, you may need to change the default repeater shift so as to
ensure compatibility with local operating requirements.
ensure compatibility with local operating requirements.
To do this, follow the procedure below:
1.
1.
Set the FT-60R’s frequency to the band on which you wish to change the default
repeater shift (144 MHz or 430 MHz Amateur Band).
repeater shift (144 MHz or 430 MHz Amateur Band).
2.
Press the [F/W] key, then press the [0(
)SET] key to enter the Set mode.
3.
Rotate the DIAL knob to select Set Mode Item 45: SHIFT.
4.
Press the [F/W] key momentarily to enable adjustment of this
Item.
Item.
5.
Rotate the DIAL knob to select the new repeater shift magni-
tude.
tude.
6.
When you have made your selection, press the PTT switch to
save the new setting and return to normal operation.
save the new setting and return to normal operation.
If you just have one “odd” split that you need to program, don’t change the
“default” repeated shifts using this Set Mode Item. Enter the transmit and
receive frequencies separately, as shown on page 28.
“default” repeated shifts using this Set Mode Item. Enter the transmit and
receive frequencies separately, as shown on page 28.
R
EPEATER
O
PERATION