Справочник Пользователя для Precor 303135-111

Assembling the AMT

Required Tools



#2 Phillips screwdriver



Rubber mallet



SAE standard socket set



Wire cutter



Two #1 Phillips screwdrivers



Torque wrench (calibrated in inch-pounds, and including
³₁₆

-inch hex wrench bit)

Unpacking the AMT

DANGER

Do not attempt to connect electrical power until

all assembly procedures are complete and the

console is properly installed.

CAUTION: Do not climb onto the AMT until directed to do so.

Follow these steps to remove the AMT base unit from its

shipping container.

To unpack the AMT:
1. Remove the rear pedestal and set it aside.
2. Remove and discard the fastener securing the back of the

center support to the shipping pallet.

3. Remove and discard the bolts and nuts securing the

wooden supports to the side arms of the AMT.

4. Remove the fasteners securing the wooden supports to

the shipping pallet, then discard the supports and the

fasteners.
Important: In the following step, do not force the foam block

placed around the center support. Doing so may damage the

plastic cover on the center support. Instead, slide the foam

block backward until you have removed it from the plastic

cover, then lift it out of the way.

5. Cut and remove the plastic ties, bubble wrap, and foam

blocks securing the unmounted parts inside the shipping

container.