Справочник Пользователя для Manhattan Computer Products ST100
5
F13: IRDETO CARD SLOT (For Models with embedded Irdeto) Insert your smart card into this slot.
We recommend that you familiarize yourself with the remote control handset prior to installing the receiver.
INSTALLATION
For digital quality picture, connect the receiver to your TV using a fully wired SCART lead. If using the UHF TV
OUT connector then follow below step.
For digital quality picture, connect the receiver to your TV using a fully wired SCART lead. If using the UHF TV
OUT connector then follow below step.
TUNING YOUR TV TO UHF OUTPUT
Connect your TV using a UHF (co-axial) lead and switch on the receiver. After initialising the digit LED (F2) will
display “NOCH”. The receiver has been factory set to channel 64. Select a spare channel on your TV and tune it
until you see the following OSD Settings menu. Finally store the settings on your TV.
Connect your TV using a UHF (co-axial) lead and switch on the receiver. After initialising the digit LED (F2) will
display “NOCH”. The receiver has been factory set to channel 64. Select a spare channel on your TV and tune it
until you see the following OSD Settings menu. Finally store the settings on your TV.
MAIN MENU
Press the MENU key to configure all your settings.
Press the MENU key to configure all your settings.
REMOTE CONTROL FUNCTIONS
Language: Select the required OSD language.
Transparency: Adjust transparency of channel banner and channel browser.
Info-Display: Select display time of the channel banner. If you select On it will
remain on until exit key is pressed.
Audio Lang / Subtitle Lang: Select default language. This sets all channels to
that language
Screen Saver: Select time to turn ON screen saver in radio mode. After the
seconds have lapsed, the screen will change to revolving radio banner.
STORE: After above settings move to store and press OK key.
Transparency: Adjust transparency of channel banner and channel browser.
Info-Display: Select display time of the channel banner. If you select On it will
remain on until exit key is pressed.
Audio Lang / Subtitle Lang: Select default language. This sets all channels to
that language
Screen Saver: Select time to turn ON screen saver in radio mode. After the
seconds have lapsed, the screen will change to revolving radio banner.
STORE: After above settings move to store and press OK key.
To select, press CH up / down or VOL up / down key. To enter, press
OK key.
OK key.
OPERATION IN PROGRAMMING MODE
The menus are designed to assist you from the
moment you switch on the receiver. Follow the help
messages at the bottom of the menu.
moment you switch on the receiver. Follow the help
messages at the bottom of the menu.