Справочник Пользователя для Alliance Laundry Systems 907003062

Electrical Requirements

70420801 (EN)

To Connect Electrical Service to the
Tumble Dryer

NOTE: The wiring diagram is located in the

junction or contactor box.

1. Install a circuit breaker as close to the tumble

dryer as possible. If more than one tumble dryer

is being installed, a circuit breaker should be

provided for each. This will make it possible to

disconnect each tumble dryer for maintenance

purposes.

2. Connect conduit-encased leads to the circuit

breaker. Connect wire leads to the appropriate

labeled terminal on the terminal block. The

ground wire must be connected to the ground

connection as shown in Figure 12.

3. Check the electrical service phase sequence

(three phase only). If one of the power leads is a

“high leg,” connect it to lead L3 in the tumble

dryer. The cylinder must rotate clockwise and the

fan must rotate counterclockwise (as viewed

from the front of the tumble dryer – with selector

switch in non-reverse position). If not,

interchange leads L1 and L2 in the tumble dryer

connection box.