Справочник Пользователя для Whirlpool W10240585C-SP

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. Once 

legs are level, make sure all four legs are snug against the floor.

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucets, and hoses.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer”.

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide”.

q

  If you live in a hard water area, use of a water softener is    

recommended to control the buildup of scale through the    

water system in the dryer. Over time, the buildup of lime  

scale may clog different parts of the water system, which will  

reduce product performance. Excessive scale buildup may  

lead to the need for certain part replacement or repair.

q

  Plug into a grounded outlet.

q

  Check that gas supply is on.

q

  Check for leaks.

q

  Select a Timed Dry heated cycle, and start dryer. Do not  

select Air Only Temperature setting.

 If dryer will not start, check the following:
 • Controls are set in a running or "On" position.
 • Start button has been pushed firmly.
 • Dryer is plugged into an outlet and/or electrical supply is

    connected.
 • Household fuse is intact and tight, or circuit breaker has  

    not  tripped.
 • Dryer door is closed.

This dryer automatically runs an installation diagnostic routine  

at the start of its first cycle.

You may notice an odor when dryer is first heated. This 

odor is common when heating element is first used. The odor will 

go away.

If you prefer to reverse the door swing on your dryer:

 A door 

reversal kit, Part Number W10277499 is available to order. For 

further information, see “Assistance or Service” section in your 

“Use and Care Guide”.

If you prefer to stack your washer and dryer:

 A stack kit, Part 

Number 8572546 is available to order. For further information, 

see “Assistance or Service” section in your “Use and Care 

Guide”.

See the “Use and Care Guide” or visit our website and reference 

Frequently Asked Questions to possibly avoid the cost of a 

service call...