Справочник Пользователя для Profoto D1 500 Air

13

www.profoto.com

1.  Mount and fasten the D1 unit on the stand using the locking knob on the Stand 

Adapter 

[18].

2.  The unit can be directed upwards/do wnwards when the Locking Knob [16] is 

loosened. Fasten the Locking Knob [16] when the unit is correctly directed.

1.  Unlock the clasp on the external reflector.
2.  Slide the reflector onto the D1 unit. Use the Zoom Scale [17] to place the reflector in 

the desired position.

3.  Secure the reflector by locking the c

lasp.

1.  Slide the umbrella shaft into the Umbrella 

Tube [15] on the D1 unit.

2.  After a few centimeters, there will be more friction.

 Continue to slide the umbrella shaft

 

some more centimeters into the tube.

1.  Ensure that the D1 unit is turned off and tha

t the power cable is not connected.

2.  If the unit has been in use,

 wait five minutes to allow the unit to be fully discharged.

3.  Gently remove the frosted glass plate.
4.  Carefully fit the glass cover in place.

 Make sure that the safety pins fit properly into the 

slot of the glass cover.

1.  Connect the power cable to the Power Supply (AC) Connector [13] on the D1 unit and 

to the mains power supply outlet. 

2.  The Power Supply Indicator [3] will be red, indicating that the unit is receiving power 

but is in standby mode.

3.  Press the On Button [2]. 
4.  The Power Supply Indicator [3] will now be green.

1.  Use the Setting Knob [7] to change the energ

y level of the flash light:

 

Turn the Setting Knob [7] c lockwise to increase the energ y level in 1/10 f-stop 
increments and counter-clockwise to decrease.

 

Press and hold down the Setting Knob [7] and turn the knob c

lockwise to increase the 

energy in 1 f-stop increments and counter

-clockwise to decrease.