Справочник Пользователя для Sony XCI-SX1

 

MSDOS 

Required file system support for mass storage 
devices  

SCSI support 

Required support for mass storage devices 

NFS support 

Required support to enable the system to be 
accessed through NFS mount 

Big Physical Area support 

Used by the camera driver to reserve large 
memory area at boot time 

 

To apply the following configurations, go to /usr/src/linux and run 
make menuconfig

 and start going through the options.  After all the 

configurations are set, exit from the configuration and make sure to save 
the changes made.  The .config file is now updated and contains the 
new configurations made. 

 
The pre-configured .config files are stored in the SDK 
/buildtree/src/kernel/normal,fme

, with which you can start 

kernel configuration. The normal/.config is used for SDK kernel. Just 
copy  .config file to /usr/src/linux then proceed make 
menuconfig.

 

 
Run make dep in order to generate dependency information and cause 
various build magic to occur.  Occasionally, cleaning up the sources 
before building from scratch is advisable.  Run make clean to delete all 
previously created object files.  To build a compressed and ready to be 
installed kernel image, run make bzImage.  This command creates the 
bzImage

 file in /usr/src/linux/arch/i386/boot/.  Lastly, run 

‘make modules’ to build the various components chosen to be built as 
modules in the previous section. 

 

 

If kernel compilation is successful, the built kernel is now ready to be 
installed.  Please copy bzImage to directory grub bootloader specify 
(Refer to UM_SDK.pdf document). In the 2GB CF SDK itself, the kernel 
is installed in /boot 

directory (Refer to /boot, 

/boot/grub/grub.conf

).