Справочник Пользователя для Sony DXC-D30WS

3-4

DXC-D30WS/P(E)/V1

3-2. BEFORE ADJUSTMENT

Note:

1. Before adjustment, connect the equipments

referring to “3-1-2. Connection”.

2. Before adjustment, Turn on POWER switch

and allow for 10-minute warm-up time.

3-2-1. Color Bar Signal Confirmation

Equipment:

Vectorscope, Waveform monitor

Preparation:

OUTPUT/DL/DCC

+ switch/camera side

→

BARS

Test point:

VIDEO OUT connector/camera side

Specification:

[for NTSC]

[for PAL]

Burst Spot 75%

3-2-2. Sensitivity Measurement Confirmation

Object:

Overall white

Light:

3200K, 2000 lux

(If the pattern box is used, set the AUTO
mode)

Preparation:
• Adjust the zoom control at “TELE” so that the white

pattern frame matches the underscanned picture frame on
the screen.

• Lens iris

→

F11

• OUTPUT/DL/DCC

+ switch/camera side

→

CAM

• WHITE BAL switch/camera side

→

PRESET

Equipment:

Waveform monitor

Specification:

100

10 IRE (for NTSC)

700

70 mV (for PAL)

[for NTSC]

[for PAL]

Note:

If the specification is not met, perform “3-3-11.

CCD OUT Level Adjustment”.

• Chroma Level

Confirm that the beam spots of each color (R, YL, G,

CY, G, B and MG) are inside the “

4” mark.

[for NTSC]

[for PAL]

Note:

• Partial difference between scale and signal

level is caused by photographic error.

• If the specifications are not met, carry out

from “3-3-2. INT SC Phase Adjustment”

through “3-3-9. Chroma (YC) Level
Adjustment”.