Листовка для Gianni Industries DG-5
Copyright Gianni Industries, Inc. All Rights Reserved.
PMUDG5 Ver. A Publish:2004.08.26 Page: 2/ 2
PMUDG5 Ver. A Publish:2004.08.26 Page: 2/ 2
2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
code the lockout facility will operate.
To Enter a User Code：
Enter the Programming mode
1. Enter the slot position code 「＊01~＊10」 →????（user code 4 digit）→（beep）
→enrolled→ Press # to exit from the programming mode, or program other operating.
2.
Note:
The codes"0000","1234" or master code are not be used for PIN code.
To Program Relocking Timer（relay）：
Enter the Programming mode
1. Press「＊20」Followed by the number of seconds the relay should open→「05」=5
seconds（01 ~99 = seconds）→（beep）→enrolled → Press 「#」 to exit from the
programming mode, or program other operating.
programming mode, or program other operating.
2. Enter「00」Sets the relay to latching mode.
(Correct code entered opens the relay,
and the relay stays open until the correct code is entered again).
To Delete a User Code：
Enter the Programming mode→ Press the slot position code of your choice to delete
(example "06") →Press「＊06」→「0000」→（beep）→delete→Press「#」 to exit
from the programming mode, or programming other operating.
from the programming mode, or programming other operating.
To Change the Master codes:
Enter the Programming mode, Enter「＊00」Followed by the new 4 digit master code→
（
（
beep）→enrolled→Enter 「#」 to exit from the programming mode, or program other
operating.
4. Wiring
diagram:
+
REED
REED
B
P
NC
NC
Com
Co
m
m
NO
NO
1
2
3
2
3
12Vdc
Power
Supply
Power Supply
Push Button
Buzzer
Tamper
Switch
Tamper switch
contact output
(free voltage contact)
Master Code
resetting(2-3)
to Factory
Code"1234"
FAIL-SAFE
LOCKING DEVICE
Contact door reed switch
Diode
This reed switch is used
to reset the re-locking time
to 0 second when the door is moved.
(Using N.O. contact in case of door closed,
changeover to N.C. When door is moved)
(Fail-safe locks)
(Fail-secure locks)
Note:
The varistor or diode must be connected across the lock terminal (electromagnet...) operated
by the device. The vartistor controls the overload produced by the strike coil (EMP).
by the device. The vartistor controls the overload produced by the strike coil (EMP).