Справочник Пользователя для Monessen Hearth ILDV20NV

4

Continued from page 3
14.  Do not use any solid fuels (wood, coal, paper, card-

board,  etc.)  in  this  fireplace.  Use  only  the  gas  type 
indicated on rating plate.

15.  This  appliance,  when  installed,  must  be  electrically 

grounded  in  accordance  with  local  codes  or  in  the 
absence  of  local  codes,  with  the  National  Electrical 
Code, ANSI/NFPA 70, or the Canadian Electrical Code, 
CSA C22.1.

16.  Do not obstruct the flow of combustion and ventilation 

air in any way. Provide adequate clearances around 
air openings into the combustion chamber along with 
adequate  accessibility  clearance  for  servicing  and 
proper operation.

17.  When the appliance is installed directly on carpeting, 

tile or other combustible material other than wood floor-
ing, you must set appliance on a metal or wood panel 
or hearth pad extending the full width and depth of the 
appliance.

18.  Do not use fireplace if any part has been exposed to 

or has been under water. Immediately call a qualified 
service technician to inspect the appliance and replace 
any part of the control system and any gas control which 
as been submerged in water.

19.  Do not operate fireplace if any log is broken.
0.  Do not use a blower insert, heat exchanger insert, or 

any  other  accessory  not  approved  for  use  with  this 
fireplace.

1.  Do not operate the fireplace with glass door removed, 

cracked, or broken.

 

It is normal for fireplaces fabricated of steel 
to give off some expansion and/or contraction 
noises during the start up or cool down cycle. 
Similar noises are found with your furnace heat 
exchanger or car engine. 

 

It is not unusual for gas fireplaces to give off 
some odor the first time it is burned. This is due to 
the manufacturing process. 

It is recommended that you burn your fireplace 
for at least ten (10) hours the first time you use it. 
Place the fan switch in the “OFF” position during 
this time.