Справочник Пользователя для Hearth & Home Technologies SL-750TV-D

23

Heat & Glo  •  SL-550 / 750 / 950TV-D  •  2053-985 Rev. H  •  9/06

WHT

WHT

BLK

BLK

If the box is being wired to a wall mounted 
switch for use with a fan (See Figure 10.5):

•  The power supply for the appliance must 

be brought into a switch box.

•  The power can then be supplied from the 

switch box to the appliance using a mini-
mum of 14-3 with ground wire.

•  At the switch box connect the black (hot) 

wire and red (switch leg) wire to the wall 
switch as shown.

•  At the appliance connect the black (hot), 

white (neutral) and green (ground) wires 
to the junction box as shown.

•  Add a 1/4 inch insulated female connector 

to the red (switch leg) wire, route it through 
the knockout in the face of the junction box, 
and connect to the top fan switch connector 
(1/4 inch male) as shown.

NOTE: Do NOT wire 
110VAC to wall switch.

If the box is being wired from the OUTSIDE of the 
appliance:

•  Remove the cover plate located on the outer shell 

right side (see Figure 10.4).

•  Install the supplied Romex

™ 

connector in the cover 

plate.

•  Feed the necessary length of wire through the 

connector.

•  Make all necessary wire connections and reattach 

the cover plate  to the outer shell.

If the box is being wired from the INSIDE of the 
appliance:

•  Remove the screw attaching the junction box/recep-

tacle to the outer shell, rotate the junction box/recep-
tacle inward to disengage it from the outer shell (see 
Figure 10.4).

•  Pull the electrical wires from outside the appliance 

through this opening into the valve compartment.

•  Feed the necessary length of wire through the 

connector.

•  Make all necessary wire connections to the junction 

box/receptacle and reassemble the junction box/
receptacle to the outer shell.