Руководство По Работе для Denso OFFICE PRO 36
7
Operating Modes
Offi ce Pro 36 operates in 2 modes, FAN Only and COOL. When in FAN Only mode, the unit
circulates the surrounding air. When in COOL mode, the compressor is operational and
cool air is circulated.
circulates the surrounding air. When in COOL mode, the compressor is operational and
cool air is circulated.
•
COOL Mode
Offi ce Pro 36 will operate in FAN Only mode for approximately 120 seconds before
the compressor engages. (Time delay setting is 120 ±15 seconds.)
the compressor engages. (Time delay setting is 120 ±15 seconds.)
•
Temperature Control
The room temperature thermistor allows the unit to switch automatically between
COOL and FAN Only modes. This is dependent upon inlet air temperature versus SET
POINT temperature.
COOL and FAN Only modes. This is dependent upon inlet air temperature versus SET
POINT temperature.
•
Fan Mode Control DIP Switch
The Fan Mode Control DIP Switch determines whether the FAN will continue to oper-
ate or stop when the compressor cycles off. (SET POINT temperature equals inlet
air or room temperature.) The unit has been preset at the factory for continuous fan
operation.
ate or stop when the compressor cycles off. (SET POINT temperature equals inlet
air or room temperature.) The unit has been preset at the factory for continuous fan
operation.
•
Temperature Scale Display DIP Switch
The Temperature Scale Display DIP Switch changes the temperature(s) that are
displayed to either °C or °F. The unit has been preset from the factory to display the
temperature(s) in °F.
displayed to either °C or °F. The unit has been preset from the factory to display the
temperature(s) in °F.
NOTE: If you wish to change the fan mode operation (COOL[OPERATE to
COOL[STOP), and/or the Temperature Scale Display (°F to °C), contact your Movin-
Cool reseller.
COOL[STOP), and/or the Temperature Scale Display (°F to °C), contact your Movin-
Cool reseller.
Emptying the Drain Tank (If equipped)
During COOL mode, condensate will accumulate in the drain tank. When the drain tank
becomes full, the FULL TANK LED will fl ash and the unit will shut off automatically.
becomes full, the FULL TANK LED will fl ash and the unit will shut off automatically.
NOTE: If you want to empty the drain tank, while the unit is in operation, press the
COOL ON/OFF button to turn the unit off. If a pro-
gram is running, you must fi rst press the Program
RUN button.
COOL ON/OFF button to turn the unit off. If a pro-
gram is running, you must fi rst press the Program
RUN button.
➀
Open the front panel.
➁
Pull the drain tank from the unit.
➂
Remove the cap and empty the drain tank.
➃
Replace the cap and return the drain tank to the
unit.
unit.
➄
Close the drain tank lid.
➅
If the Program RUN LED is fl ashing, press the
COOL ON/OFF button to continue running the
program. If the Program RUN LED is illuminated
continuously, no further steps are necessary. If
no program exists or the program was deacti-
vated, press the COOL ON/OFF button to restart
the unit.
COOL ON/OFF button to continue running the
program. If the Program RUN LED is illuminated
continuously, no further steps are necessary. If
no program exists or the program was deacti-
vated, press the COOL ON/OFF button to restart
the unit.